FANDOM


XFiPrelude

ManufacturerEdit

  • Auzentech

SpecificationsEdit

  • Creative X-Fi CA20K audio processor
  • One AKM AK-5394 super high performance 96kHz 24-bit ADC for analog input
  • Four AKM AK-4396 96kHz 24-bit advanced multi-bit DAC for analog output
  • 64Mbytes of memory for audio processing
  • High fidelity audio OPAMPs for analog input and output (TI OPA2134)
  • Front L/R output OPAMP is replaceable by end-user (National LM4562NA)
  • Dual mode S/PDIF receiver and transmitter

Technical SpecificationsEdit

  • 24-bit Analog-to-Digital conversion of analog inputs at 96kHz sample rate
  • 24-bit Digital-to-Analog conversion of digital sources at 96kHz to analog 7.1 speaker output
  • 24-bit Digital-to-Analog conversion of stereo digital sources at 192kHz to stereo output
  • 16-bit to 24-bit recording sampling rates:32, 44.1, 48 and 96kHz
  • ASIO 2.0 support at 16-bit/44.1kHz, 16-bit/48kHz, 24-bit/44.1kHz 24-bit/48kHz and 24-bit/96kHz with direct monitoring.
  • Enhanced SoundFont support of up to 24-bit resolution
  • 64MB of X-RAM

Audio PerformanceEdit

  • Signal-to-Noise Ratio (20kHz Low-pass filter, A-Weighted)
  • Stereo Output : 120dB (part spec)
  • Front and Rear Channels : 120dB (part spec)
  • Center : 120dB (part spec)
  • Subwoofer and Side Channels : 120dB (part spec)
  • Total Harmonic Distortion + Noise at 1kHz (-3dBFS, A-weighted) : 0.001% - part spec
  • Frequency Response (+/-0.01dB, 24-bit/44.1kHz input ) : 20khz (part spec)
  • Frequency Response (+/-0.01dB, 24-bit/96kHz input ) : 43.5 khz (part spec)
  • 16-bit to 24-bit recording sampling rates: 32, 44.1, 48 and 96kHz

ConnectivityEdit

  • One 3.5mm MIC input connector in rear panel
  • One 3.5mm line input connector in rear panel
  • One 4-pin AUX connector on board
  • Four 3.5mm 8 channel line output connectors in rear panel (FL/FR/C/SW/RL/RR/RSL/RSR)
  • One S/PDIF combo input connector in rear panel for receiving either coaxial or optical digital
  • One S/PDIF combo output connector in rear panel for transmitting either coaxial or optical digital
  • One 10-1pin front panel connector on board for MIC input and headphone
  • One 40-pin digital extension header on board to support AD-Link and other digital functionality

Ad blocker interference detected!


Wikia is a free-to-use site that makes money from advertising. We have a modified experience for viewers using ad blockers

Wikia is not accessible if you’ve made further modifications. Remove the custom ad blocker rule(s) and the page will load as expected.